Digital Display (Percentage)
Three (3) second to start-time frame: Monitored equipment has (3) seconds from start to run.
(The equipment does not have to reach operation speed).

Monitors acceleration to (Normal) operation speed. If monitored equipment should overload before reaching (Normal) operation speed, shut down will occur before damaging monitored equipment.

De-acceleration before reaching operating speed feature

Status Indicators - L.E.D.
10% Speed Reduction - 20% Speed Reduction: Arm (will light when monitored equipment reaches 90% of normal speed during startup), Target.

Outputs

Relay Outputs:	10% Speed Reduction-Common-N/O-N/C Relay Contacts 20% Speed Reduction-Common-N/O-N/C Relay Contacts Alarm output: Common-Normally Open
4-20 milli-amp out:	12 milli-amp=100%

Wiring

Stand Alone Unit:

All terminals-power-etc, on CPU printed circuit board. Display PC board can be remotely mounted

Ratings	Easy Calibration
Relay contacts rated 3 or 7 AMPS @ 250 VAC depending on model	Calibration is accomplished by using a one turn potentiometer

Digital temperature equipment sensors can be used for hot bearing and/or belt misalignment sensing.

Model MT DT
Back lighted LCD display
Displays 16 characters by 2 lines - alphanumeric

Supply Power
Relay output 4 AMP SPST (N/O or N/C SELECT)

Trip #1
Temperature Alarm adjustable (-15° to +230° F)

Trip #2
Rate of rise adjustable (1° to 99° F)

Signal Input
Type T thermocouple (UNGROUNDED)
1 to 24 Inputs single ended (25 Pin Min. D)

Scan Rate
Adjustable from 1.0 to 4.0 seconds
Scan is selectable for automatic or manual
Each point can be operator programmed with alphanumeric characters
Each alarm point can be turned ON or OFF
Temperature display in Degree C or F

Options
RS485 - For remote operation (Input-Output)
Isolated and fault protected
Plug in connector for signal input - 24 inch pigtail for wire splice connections

Trip #2
Rate of rise adjustable (1° to 99° F)