The FM200 Multi-Application Flow Monitor is very effective in monitoring FLOW/NO FLOW conditions in pipes, chutes spouting , etc. Its Sensing Techniques, which use both Microwave and Doppler, makes the FM200 versatile for almost any FLOW/NO FLOW application. The following are some of the Unique Advances Features that allow this product to exceed the industry standards.

Central Processing Unit

• Monitors movement of most anything through a pipe or chute system (Air-Liquids-Solids)
• Sensor externally mounts to the outside of the pipe or chute.
• Senses solids in Pneumatic Air System- (Presence or Absence).
• Adjustable Sensitivity - Per application demand.
• Monitors Pipe System - ½" to 60" or more.
• Prepunched for:
  • ½" conduit (1 Ea.)
  • ¾" conduit (1 Ea.)
  
• P.C. Board Outputs:
  • TTL -0-5 Volt
  • RS232 - Low/High/Output
  • Relay: -4 Amp - 125 / 250 VAC
  • Normally Open Contact
  • Normally Closed Contact
• 3 User Select Sensitivity Ranges
  • Low
  • Medium
  • High
• Full adjustment of sensitivity across each range.
• Stand-alone System
• Easy Installation
• No Maintenance
• L.E.D. Indicators
  • Flow (Green)/No Flow (Red)
• All Circuits Supervised
• Housing NEMA 3/4/12

Sensor

• Mounting Tabs for easy installation
• Prewired with 3' 18ga. 2 conductor wire
• Low voltage 5V DC, 200 MA Maximum
• NEMA 3/4/12 Enclosures
• NEMA 7/9 Enclosures
• Available for 12VDC, 24 VAC, 220 VAC

MODELS AVAILABLE (With or Without L.E.D. Indicators)

Sensor Installation